CHIEF SIMULATION ENGINEER- AEROSPACE AND DEFENSE

CHIEF SIMULATION ENGINEER- AEROSPACE AND DEFENSE

Bullisher is a data centric fintech Solution provider in the aerospace and defense industry for institutional level investors, looking to disrupt and revolutionise a $3 trillion dollar industry. We spearhead an industrial-leading Blackbox to facilitate and administer trade agreements pioneered by a vehicle, driven by our new generation benchmark delivering solutions through innovation with uncompromising agility. Predicts trends in the aerospace and government defense entities, predicts trends in political shifts and the ability to influence actual effect changes in government policies through innovation.

JOB DESCRIPTION:

The oversight requires you supporting a real-time explicit simulation program capable of simulating time-dependent stress relaxation. The ability to add material model relaxation to any of the hyper elastic models supported in the interfaces capable of adding material component to a material models that represents material relaxation as a function of time. Areas to cover will include: contact scoping, enhancement of material support, shell and beam in 3D analyses to interact with other bodies, surface interference function exponent define to be able to get to preloaded states, documentation for summary of new developments improvements and post-processing improvements. The following ability to define user defined mass.  An application that represents a very complex specification with our own specific inertia quantities in rigid dynamics analysis to replace a complex geometry by a simpler ones. Design experiment based on tagging different parameters with complex loading conditions. METHODS TO FOLLOW: Automated ways of symboling assembling segments together interface time step and model descriptions. The ability to produce customize results used to analyze joint results within the interfaces. Fully implicit that can handle a surface tension-A model applicable to unidirectional layers that’s able to predict damage in the matrix prior to full failure. This provides us a tremendous capability of being able to simulate this complex behaviour very accurately. Areas to cover will include:(model the forces transmitted across a bolted joint, including preload, clearance gaps). The end result of these can also be simulated. This number of components may change, the data Acquisition might evolve over time. An Additional value will drive new requirements and new features-From the edge where command & controls are effective by current conditions all way to the edge data centre where data analytics are performed for example; predictive maintenance, and continuous process improvement. Areas where matters require attention- (Prepare incremental plans for large instrumentation and data Acquisition)- The automatic discovery process will take care of finding all the communications endpoints and appropriately connecting them. The ability to Standardized our architecture interface definitions that allows easy reconfiguration between different engine testing. You will micromanage the current optics modeling engineers team with other small team of System Testing Engineers, control system design engineers, application engineers, system architects, DevSecOps. We are a startup enhancing the formation of early stages of a product development project.

PHYSICAL DEMANDS: This position requires the ability to communicate and exchange information, utilize equipment necessary to perform the job.

ENVIRONMENT: This position will operate in the following areas of the organization regulatory engineering division”MULTIDOMAIN DEFENCE DOCK:

MULTIDOMAIN DEFENCE DOCK“ Standard engineering lab environment ”

Employees must be legally authorized to work in the UK.Verification of employment eligibility will be required at the time of hire. Visa sponsorship is not available for

this position.

QUALIFICATIONS AND KEY REQUIREMENTS:

• BEng or MEng Mechanical Engineering degree, CSSLP, GSEC, OSCP, and PSE, (Professional Simulation engineering certification) is essential or any of the listed three DoD 8570 Certifications.
• Extensive experience with parametric CAD and CAE, modelling tools, E.g SolidEdge, to generate 3D modelling and 2D drawings, simulation engineering
• Solid working experience of GD&T and geometric tolerancing and structural FEA is essential
• 20yrs + Experience of designing for electronic components including: thermal management, vibration and temperature

INTERVIEW PROCESS:

• STAGE 1: COGNITIVE ABILITY TEST
• STAGE 2: COGNITIVE ASSESSMENT SCREENING: WITH A 30yrs+ EXPERIENCE PSYCHOLOGIST:
• STAGE 3: PRE-SCREENING (verification checks & DV security clearance)
• STAGE 4: INTERVIEW WITH THE: CEO, CTO & GC